Axial Compressors
An Enhanced Compressor Sub-Idle Map Generation Method Luis E. Ferrer-Vidal, Vassilios Pachidis, Richard J. Tunstall (2018), DOI:
Effects of Secondary Air Removal on the Aerodynamic Behaviour of Compressor Cascade Flow Thorben Aufderheide, Jens Friedrichs, Bernd Becker (2018), DOI:
Controls and Diagnostics
Towards an Integrated Approach for Micro Gas Turbine Fleet Monitoring, Control, and Diagnostics Ioanna Aslanidou, Valentina Zaccaria, Moksadur Rahman, Mark Oostveen, Tomas Olsson, Konstantinos G. Kyprianidis (2018), DOI:
Dynamic Modeling of an Industrial Gas Turbine in Start-Up Mode Using Monitoring Data Abdollah Mehrpanahi, Ali Ghorbanifar, Ali Hamidavi, Hero Salahifard (2018), DOI:
Cycle Innovations and Power Systems
Enabling efficient and low emissions deep part load operation of combined cycles and combined heat and power plants with external Flue Gas Recirculation Johan Steimes, Sikke Klein, Marco Persico (2018), DOI:
Influence of Multiple Degrading Components on Gas Turbine Fuel Cell Hybrid System Lifetime Valentina Zaccaria, Alessandra Cuneo, Alessandro Sorce (2018), DOI:
Modeling, Analysis and Multi-Objective Optimization of Adding Recuperator on Techno-Economic Properties of Mgt-70 Gas Turbines A. Pourjafar, A. Mehrpanahi, S. Nikbakht Naserabad, H. Salahifard (2018), DOI:
Impact of Gas Turbine Cyclic Operation on Engine Aging – an Investigation of the GT24/GT26 Fleet Moritz Lipperheide, Frank Weidner, Martin Gassner, Stefano Bernero, Manfred Wirsum (2018), DOI:
Performance Analysis and Prediction of Compressor Fouling Condition for a Twin-Shaft Engine Shaojuan Geng, Bing Bai, Hongwu Zhang, Jichao Li, Chaoqun Nie (2018), DOI:
Heat Transfer and Combustion
Roughness effects on flow and heat transfer in a ribbed duct considering additive manufacturing Edward Kilpatrick, Sung in Kim (2018), DOI:
Shape Optimization in Low-Order Thermoacoustic Networks José G. Aguilar, Matthew P. Juniper (2018), DOI:
Nozzle Pressure Side Film Cooling and Endwall Phantom Cooling Kevin Liu, Luzeng Zhang, Michael D. Fox (2018), DOI:
Heat Transfer Coefficients in a Turbocharger With and Without Boiling Thomas-Sebastian Gier, Thomas Biesinger, Henning Eickenbusch (2018), DOI:
Investigating the Change of Discharge Behaviour of Gas and Liquid by Means of Analytical and Numerical Approaches Laura Cordes, Lisa Hühn, Corinna Schwitzke, Hans-Jörg Bauer (2018), DOI:
The Influence of Inlet Corner Shape on the Static and Dynamic Performance of an Annular Pressure Seal Luis San Andrés, Jing Yang (2018), DOI:
Oil & Gas
Parametric Assessment of a Surge Severity Coefficient Enrico Munari, Mirko Morini, Michele Pinelli, Klaus Brun, Sarah Simons, Rainer Kurz (2018), DOI:
Performance Degradation Effects in Modern Industrial Gas Turbines Dan Burnes, Rainer Kurz (2018), DOI:
Radial Turbomachinery
Steam Turbines
Development of Hot Standby Mode for flexible Steam Turbine Yevgen Kostenko, David Veltmann (2018), DOI:
Modelling of Angle Controlled Engagement for a Single Shaft CCPP with Mechanically Decoupled LP Turbine for Maximum Heat Extraction Dr. Carmen Stüer, Dr. Gerta Zimmer (2018), DOI:
Fast Numerical Calculation Approaches for the Modelling of Transient Temperature Fields in a Steam Turbine in Pre-Warming Operation with Hot Air Piotr Łuczyński, David Erdmann, Dennis Többen, Manfred Wirsum, Klaus Helbig, Wolfgang Mohr (2018), DOI:
Structures and Dynamics
Influence of Aerodynamic Damping on Torsional Vibrations of Turbine Shafts Christopher E. Meinzer, Christian Keller, Joerg R. Seume, Olga Korolova, Bernd Ponick (2018), DOI:
Modelling the Rubbing Process in Labyrinth Seals Oliver Munz, Corina Schwitzke, Hans-Jörg Bauer, Sarah Welzenbach, Tim Fischer, Sonun Ulan kyzy (2018), DOI:
Turbines
Impact of Purge Flows on the Unsteady HPT Stator-Rotor Interaction Stefan Zerobin, Andreas Marn, Franz Heitmeir, Emil Göttlich, Andreas Peters (2018), DOI:
Aerodynamic Investigation of an Embedded Uhbrengine Concept Constance Heykena, Jens Friedrichs (2018), DOI: